Liner discolouration
If your MSpa liner is experiencing discolouration check out the relevant advice below depending on the type of discolouration:
Colour of the Liner Faded
This might be caused by products such as washing detergent, moisturiser, make‑up, sun lotion or fake tan, etc. We would suggest using washing up liquid, stain remover or miracle pads to remove stains or marks.
We would advise that not to leave the spa in direct sunshine. We would suggest setting the spa up under a spa cover or a canopy to help protect the spa.
We also suggest that the spa is tested with the chemical test strips daily to check pH and Alkalinity values.
Unfortunately, this is not a manufacturing defect and we will not be able to replace this under warranty for you. Replacement liners can be purchased from your local distributor or service partner.
Mould on the Liner
Mould can occur if the spa is not completely dry when put away or if water becomes trapped between the liner and the cover. The humidity from the spa in conjunction with the trapped water can cause mould to grow and for the water to be stagnant.
By keeping the water treated with the correct chemical levels and maintaining the spa you should avoid issues such as this. However should the issue arise we would advise to use a solution of water and washing up liquid to remove the mould. If the mould is inside the liner we would suggest spraying some mould spray through the inflation valve and then inflating and deflating the spa several times. This will reduce the mould but may not get rid of the marks completely.
Unfortunately, this is not a manufacturing defect and we will not be able to replace this under warranty for you. Replacement liners can be purchased from your local distributor or service partner.